Features

Superior energy efficiency
Our system compressors ramp up or wind down based on the needs of each room to maintain better comfort. Our heat pump systems are 160% more efficient than gas-burning furnaces.

Most homeowners think that in order to stay cool in summer and warm in winter, they’ll have to suffer with high utility bills. Mitsubishi Electric Heating and Air Conditioning systems can’t control utility prices, but they can control your energy consumption.

The Systems Are Far More Efficient Than Traditional HVAC Systems:
• Homeowners report an instant improvement in their electric bills
• The units are up to 40 percent more efficient than window air conditioners
• They do not waste energy starting and stopping all day like traditional heat pumps
• The systems use only the precise amount of energy needed to maintain comfort
• No energy is wasted cooling or heating unoccupied rooms

Where’s All the Money Going?

Central air and other similar ducted systems are catch-all heating solutions that lack the precision and control of their ductless counterparts. When a forced air system works to cool or heat your home, you have little control over where that air goes. This means that vacant rooms are getting the same amount of energy and service as your favorite spots in the house. It’s wasteful, inefficient and expensive to cool or heat the basement storeroom the same way you cool or heat the kitchen or bedroom. But a ducted system doesn’t allow for that kind of precise control. So the cold or warm air flows throughout your home and you see the results of this inefficiency on your utility bill every month.

Traditional HVAC Fall Short
Thermostat placement is rarely conducive to providing accurate comfort control in other areas. For example, thermostats can often be found in a home’s master bedroom. When the temperature in that room is adjusted, the children’s room across the hall may not be receiving the comfort that it needs.

Ductwork tends to run through uninsulated spaces, which leads to thermal heat loss. If there is a leak in the ductwork, or if flex-ducting is pinched due to improper installation, duct-loss will lead to wasted energy as the system has to compensate for the wasted energy.

Conventional systems use a standard single speed compressor that can only run at full speed. This means that the system works at full capacity until the desired temperature is achieved, then shuts off. As the temperature changes, this cycle repeats and can create uncomfortable drafts and expensive energy spikes.

Our ductless system uses an INVERTER-driven compressor to provide exact control 100 percent of the time. They constantly adjust to even the slightest temperature changes in the room so that it doesn’t fluctuate – and they don’t waste money or energy on the zones where you spend little time. The ductless unit is installed to deliver room-by-room comfort in the spaces you choose. The majority of your cooling and heating energy (and money) goes where you need it, and not where you don’t. In this way, you get personalized comfort in the rooms you use most. This is known as “zone control”. Even More Ways to Save Most ductless systems have earned the ENERGY STAR, which means savings as they operate, as well as applicable ENERGY STAR rebates. Some units are eligible for state or federal tax credits, or local utility discounts.